Joined in 2023 
82 
63 About this deal
I went to IKEA, ventured over to the as-is section, and bought a pre-drilled door that was pretty scratched up, but otherwise structurally intact. The Milescraft door hinge jig is a template system that provides guides not just for door hinges but for the door jamb, strike plate, and latch plate. WORD OF MOUTH: Invite your friends to come, discover the platform and the magnificent 3D files shared by the community!
IKEA Sektion Ultrusta Cabinet Hinge: Making a Template IKEA Sektion Ultrusta Cabinet Hinge: Making a Template
Next, measure in and mark with a pencil two points above and below the mark made in the above step and join them together then, using a carpenters square, extend the horizontal mark made above until it hits the vertical line. Either way works Kha, but yes I’d be tempted to junk the plastic inserts and screw directly into the cabinet. As you can probably see, this jig cuts down the plastic by about 90% and has a no-frills approach to providing a simple yet adjustable hinge jig for your concealed cabinet doors.
Even skilled carpenters usually turn to a door hinge jig to ensure the fast, accurate positioning of door hardware. Want to use the new style, IKEA Ultrusta cabinet hinges from the new Sektion system on a custom build project? Once adjusted suitably to allow the door to open and close without touching or binding on any surrounding surfaces you’re pretty much done, good job! If your using a hand held drill then I'd make a jig, drill a hole in a scrap of MDF and put a stop on it so that you can just hold the jig to the door and drill through the existing hole. I bought the Kreg jig described by one of your readers but could not for the life of me figure out how to adapt it to our situation.
Templates | Blum Templates | Blum
These allow the BI-DTool jig to be used for smaller hinges, though the required cutter is not included.
Guide holes are also provided for the hinge retaining screws, though the required 1/16-inch drill bit is not included.
35mm Hinge Jig, Double Clamp Cabinet Hinge Cutter Riiai 35mm Hinge Jig, Double Clamp Cabinet Hinge Cutter
Cabinet hinge jigs almost always include the Forstner bit required to drill the flat-bottomed hole for the main body of the hinge. another tip is to drill the hinge position into one of IKEA’s very own handle templates ( https://www. It can be used with doors from 1⅜ to 2½ inches thick, and with hinge sizes from 2½ to 6 inches, in ½-inch increments.If you need to use more hinges divide the space between the top and bottom marks equally depending on how many hinges you are adding e. I was adding new Ikea doors and the Ultrusta hinges to older cabinets where the holes just don’t line up with the hinges.
Great Deal 
New Comment